Release Notes

Fixed an issue that could cause excessive battery drain on units initialized with inadequately powered USB hubs

Fixed an issue that on certain devices was causing a higher than average current consumption in Reset mode

Fix for 16CPAN03: Replace inadvertently removed code that performed detection and modification of proper bandwidth settings based on calibration values.
Modified inactivity threshold to allow for more consistent timing for entering sleep mode.
Fixed race condition in USB code that could allow data corruption if new requests were received before previous requests were completed.

Fixed an issue introduced in version 1.6.0 that incorrectly rotated the axes of the accelerometer by 90 degrees about the Z-axis.
ActiGraph will be providing a batch processing tool to repair files.
Please note that while the orientation shift issue is present, there has been no loss of data.

Added the ability to resume data collection from HALT mode due to low or dead battery via the CentrePoint Sync Mobile App without the need to download data first.
Added the ability to use a single unit for proximity to be both receiver and beacon.
Improved battery life when device is used with CentrePoint Sync Mobile App.
Improved correlation between on-board epoch data and ActiLife processed epochs from the Raw data.
Made general battery improvements through software optimizations.
Fixed a bug that could cause logging a heart rate monitor disconnect event prior to the start time.
Throttle down processor after 10 seconds of idle time while charging to reduce heat buildup.